Q: Can a
door be painted with a roller?
A: Yes and
no. Any roller will put a small amount of texture into the paint, which is
something you typically don't want with a smooth surface such as a door. If you
want, however, you can use a roller to speed up the application of the paint
onto the door, and then smooth out the texture using an appropriate paintbrush.
Q: What do the
measurements such as 1/2-inch and 3/4-inch mean on a paint roller cover?
numbers refer to the length of the roller nap. Shorter naps hold less paint and
leave behind less of a texture, while longer naps do just the opposite. You
should match the length of the nap to the relative roughness or smoothness of
the surface you're painting – short naps for smooth surfaces, longer naps for
rougher surfaces. For a door, use the shortest nap possible, or use a roller
made of foam.
Q: Is it
really necessary to paint the top and bottom edge of a door?
This is commonly overlooked, even by the pros, but painting the top and bottom
edges helps protect the door from uneven absorption of moisture. Also, if a new
door warps and the edges have not been painting, it will typically void the
Q: Is there
any special technique to painting a paneled door?
A: The two
real tricks to getting a good paint job on a paneled door is to paint in a set
sequence, and to always paint with the grain instead of across it. The typical
sequence is to paint each of the panels first, starting from the top left and
working down to the bottom right. Next, paint each of the horizontal rails of
the door, again from top to bottom. Finally, work from left to right and paint
the vertical stiles, and then the edges. You should always paint the entire
door at one session, to avoid ending up with hard-to-remove paint edges.
the best method for painting several doors at once?
A: Pick an
open area, such as a garage, then cover the floor with paper or a tarp. Take
two of the doors, and stand them up at roughly 45 degrees to each other, with
about 8 inches between them. Take a small piece of scrap wood such a piece of
lath, lay it on top of the two doors, and tack it to each door with one nail
through the top. This will hold the two doors upright and at an angle to each
other, giving you access to all four faces, all four edges, and both tops. You
can set up additional doors in the same manner, reversing the angle with each
one, so the doors are set up accordion-style. Once all the doors have been
painted, take the wood off the tops one at a time, touch up the top where it
was covered by the piece of wood, then lay the door carefully on a pair of
sawhorses and paint the bottom before rehanging the door.
Q: Can the
doorknob be masked around, or does it need to be removed?
A: You will
get a better paint job if the knob is removed, because you can paint vertically
with the grain right over the doorknob hole, instead of painting around the
knob which often leaves brush marks. Also, by the time you have masked the knob
on both sides and spent the additional time to carefully brush around it,
you'll find that you don't really save any time over having just removed the knob
in the first place.
Q: If a
door is being painted in place, what about the hinges?
doors are equipped with three pair of hinges, and you can safely unscrew and
remove the middle one temporarily while you paint. For the other two, place a
piece of 2-inch-wide masking tape over the hinge, then run the tip of a razor
knife in the gap between the hinge edge and the door mortise. Remove the excess
tape from the door, and the hinge will be perfectly covered. If you do a lot of
painting, there are also hinge covers available from most paint stores. The
covers are made to match the size of most common hinges, and snap in place to
cover the hinge temporarily.
Q: When painting a door one color on one side and another
color on the other side, what color should the edges be?
common rule of thumb is to paint the edge of the door the same color as the
room it faces. For example, suppose you have a white hallway and a blue
bedroom, and you want to paint one side to match the hall and the other to
match the bedroom. Assuming the door opens into the bedroom, you would paint
the edge with the hinges white, since it faces the hall when the door is open,
and you would paint the edge with the latch, which faces the bedroom when open,
and repair questions? E-mail Paul at [email protected].
What's your opinion? Send your Letter to the Editor to